Specifications

5
01023052
Culligan High Efciency Twin Softener—Upow Regeneration
Model 9" Model 10" Model
Control Valve 1” Reinforced Thermoplastic with HE Circuit Board
Overall Conditioner Height 56 in 62 in
Media Tank Design Quadra-Hull
™
Media Tank Dimensions (Dia x Ht) 9 x 48 in 10 x 54 in
Salt Storage Tank Dimensions (Dia x Ht) 18 x 43 in
Exchange Media, Type and Quantity Cullex
®
Media, 1.0 ft
3
Cullex Media, 1.5 ft
3
Underbedding, Type and Quantity Cullsan
®
Underbedding, 12 lb Cullsan Underbedding, 15 lb
Exchange Capacity @ Salt Dosage Per Recharge
17,854 gr @ 4.0 lb 26,781 gr @ 6.0 lb
27,108 gr @ 8.0 lb 40,662 gr @ 12.0 lb
31,736 gr @ 12.0 lb 47,604 gr @ 18.0 lb
Efficiency rated dosage
1
4,463 gr/lb @ 4 lb salt dosage 4,463 gr/lb @ 6 lb salt dosage
Proportional Brining Efficiency Rating
2
5,250 gr/lb @ 4 lb salt dosage 5,247 gr/lb @ 6 lb salt dosage
Freeboard to Media
3
14.5 in 14.5 in
Freeboard to Underbedding
4
44.5 in 47.5 in
Salt Storage Capacity 375 lb
Rated Service Flow @ Pressure Drop 9.0 gpm @ 11 psi 9.4 gpm @ 12 psi
Auxiliary Flow Rate
5
10.8 gpm @ 15 psi 11.3 gpm @ 15 psi
Total Hardness, Maximum 30 gpg
Total Iron, Maximum 2 ppm
Hardness to Iron Ratio, minimum 8 gpg to 1 ppm
Operating Pressure 20-125 psi [138–862 kPa]
Operating Pressure (Canada) 20-90 psi [138–621 kPa]
Operating Temperature 33-120°F [0–49°C]
Electrical Requirements 24V/60 Hz
Electrical Power Consumption, Min/Max 8.4 watts/21.6 watts
Drain Flow, Maximum
6
2.5 gpm
Recharge Time, Average
7
Recharge Water
78 minutes 67 minutes
Consumption, Average
7
47 gallons 45 gallons
1 The efciency rated dosage is only valid at the stated salt dosage and is efciency rated according to NSF/ANSI 44.
2 The Proportional Brining Efciency Rating assumes a 20 percent reserve capacity at the time of regeneration that is typical
of what the manufacturer expects under real-world operation. Proportional brining is not measured by NSF/ANSI 44, and
so this cliam is not, and can not, be rated to NSF/ANSI 44.
3 Measured from top of media to top surface of tank threads. (backwashed and drained).
4 Measured from top of underbedding to top surface of tank threads.
5 Auxiliary ow rates do not represent the maximum service ow rate used for determining the softener’s rated capacity and
efciency and that continuous operation at these ow rates greater than the maximum service ow rate may affect capacity
and efciency performances.
6 Backwash at 120 psi (830 kPa).
7 10 minute backwash, 4 lb. 9” model, 6 lb. 10” model, 7 lb. 12” model, or 12 lb. 14” model salt dosage