Quick Reference

OPERATING INSTRUCTIONS
8. Fill your beverage bottle to the max fill line using cold purified water
or tap water.
9. Tilt beverage bottle under the carbonating stem (see fig. d) and push
beverage bottle vertically into the tilt head (see fig. e).
10. Rotate the bottle counter-clockwise until securely in place.
Note: Hand tighten only. Do not use tools.
ASSEmBLy INSTRUCTIONS CONTINUES
1. Make sure your Sparkling Beverage Maker is properly assembled
(see Assembly Instructions).
2. Always operate unit with a beverage bottle. Be sure that the water
level is at the max fill line. NOTE: Beverage bottle is NOT
dishwasher safe.
3. Never operate with soda syrups or ingredients inside the beverage
bottle during the carbonation phase.
4. Do not remove recyclable CO
2
cartridge if you have started the
carbonation process.
5. Gently press down on the carbonating activation lever on the top of
the unit (see fig. f) to carbonate water.
6. Release the carbonating activation lever.
7. Repeat Step 5 in two-second bursts, leaving a few seconds in
between each burst, until you have reached the level of carbonation
desired (See Tips & Hints pg 7).
8. Once finished, pull the beverage bottle (attached to the tilt head)
away from the unit to release the pressure.
9. Rotate the beverage bottle clockwise until it releases from the
tilt head.
10. Add optional soda syrups or ingredients from recipe booklet to the
beverage bottle. Note: Be sure to tip the beverage bottle at a
45-degree angle before pouring in soda syrups or other flavorings.
11. Twist the bottle cap onto the beverage bottle. Gently rotate left to
right until soda syrups or ingredients have mixed together.
Note: Never shake bottle to mix.