- Motorola Digital Return Transmitter Installation Sheet
Table Of Contents
- Installation Sheet
- Related Documentation
- Document Conventions
- Before You Begin
- Installing the SG2-DRT-3X in the SG2440 Node
- Installing the SG2-DRT-3X in the SG2440 Node in a 1X or 2X Configuration
- Installing the SG2-DRT-3X in the SG2000 Node
- Installing the SG2-DRT-3X in the SG2000 Node in a 1X or 2X Configuration
- Specifications
- SG2-DRT-3X DWDM Models
- SG2-DRT-3X CWDM Models
- If You Need Help
- Caution/Compliance
- Declarations of Conformity
- Copyright
- Back Cover
6 STARLINE
SG2-DRT-3X Installation Sheet
TP XMTR A and Pad XMTR A are not used, therefore, it is not necessary to pad the
XMTR A location as no signal is present.
8 Close the housing and use a torque wrench to progressively tighten the housing bolts to a
final torque of 12 ft-lbs. in the sequence stamped on the housing lid.
Figure 6 illustrates a properly installed and cabled SG2-DRT-3X:
Figure 6
SG2-DRT-3X installed in SG2440