Use and Care Manual

7
The selected plate(s) and the
corresponding temperature(s) will
appear on the LCD screen.
2. Turn the temperature dial for the
selected plate(s) to the desired setting
– from Warm to 450°F. The temperature
readout(s) in the LCD screen will
change as you turn the dial.
NOTE: Warm setting will display
as 200°F.
In the example below, the lower plate
temperature has been set to 350˚F.
3. Once the desired temperature setting(s)
have been selected, press the START/
STOP button.
NOTE: If the START/STOP button is not
pressed within 10 minutes, the unit will
enter sleep mode. Turn any knob or
press any button to reactivate the unit.
a. The LED light around the START/
STOP button will illuminate and the unit
will beep one time.
b. In the LCD screen, PREHEAT will
appear and the selected temperature(s)
will flash as the plate(s) heat up. It may
take up to 20 minutes to reach
operating temperature, depending on
the temperature(s) selected.
c. When the plate(s) reach temperature,
the selected temperature(s) will stop
flashing, READY will display, and the
unit will beep 3 times.
NOTE: If both plates are selected,
when the first plate reaches
temperature it will show READY and
the unit will beep 1 time; you can begin
cooking on this plate if you choose.
The second plate will continue to
preheat until it reaches temperature, at
which time it will show READY and the
unit will beep 3 times.
In the example below, the upper plate
temperature has been set to 250˚F and
is ready, and the lower plate
temperature has been set to 350˚F and
is still preheating.
4. To change the temperature(s) at any
time during operation, simply turn the
temperature dial of the selected plate(s)
to the new setting.
a. If the plate(s) are in PREHEAT mode,
they will continue to preheat to new
selection.
b. If the plate(s) are in READY mode
and the temperature(s) are lowered,
READY will remain on display as the
unit adjusts to the lower temperature(s).
c. If the plate(s) are in READY mode
and the temperature(s) is raised,
PREHEAT will display and the higher
selected temperature will flash as the
plate(s) heat up. Once the higher
temperature(s) is reached, READY will
display, the temperature(s) will stop
flashing, and the unit will beep 3 times.
5. To change the plate selection at any
time during operation, simply turn the
PLATE SELECT dial to the new
selection and adjust the plate(s)
temperature (if necessary). PREHEAT
will display for new selected plate(s)
and the temperature will flash as the
plate(s) heat up. Once the new
temperature(s) are reached, READY will
display, the temperature(s) will stop
flashing, and the unit will beep 3 times.