Technical data

7
4. With the stem facing down, place the
assembly over the center hub. It should
fit snugly and rest on the bottom of the
work bowl.
5. Place work bowl cover onto work bowl,
with the handle area just to the left of
center. Turn counterclockwise to lock onto
work bowl.
6. Align pusher with the feed tube opening
on the work bowl cover and slide the
activating rod down to the bottom.
7. Use the cord wrap on the housing base
underside to add or remove cord.
8. You are now ready to operate
the machine.
BLADE AND DISC
INSTRUCTIONS
The Cuisinart
®
Blade and Disc Holder holds:
one stainless steel blade, one dough blade,
one detachable disc stem, and three food
processor discs.
Note: This unit comes with one medium
slicing disc and one medium shredding
disc. Additional discs available at
Cuisinart.com
The transparent cover locks to the base with
a tamper-resistant lock that will not open if
the blade and disc holder should tip over.
All blades and discs, like sharp knives,
should be stored out of the reach of
children.
OPERATING
THE LOCK
To open the lock, pull the
knob out toward you and
turn clockwise 90º. This
sequence will unlock the
lock. Gently lift up the
transparent cover. Do not
force the cover open
when the knob is in the locked position. The
knob will automatically return to the locked
position when the cover
is closed.
CAUTION: Do not twist the lock back to
the locked position when the transparent
cover is open, as doing so may break
the lock.
INSERTING ACCESSORIES
The blade and disc holder stores a metal
blade in the left triangular cavity and a plastic
or metal dough blade in the lower center
triangular cavity. Hold each piece carefully
by the center hub, and insert with its upper
blade facing down. WARNING: DO NOT
TOUCH METAL BLADE, AS DOING SO MAY
RESULT IN INJURY.
The detachable disc stem fits in the round
opening in the upper center section of the
blade and disc holder. Insert the disc stem
face down, with the rounded left side of the
semi-circular connector toward the back.
Icons embossed on the inside surface of
the blade and disc holder show proper
placement of the blades and detachable
disc stem.
INSERTING AND
REMOVING DISCS
INSERTING DISCS
There are three disc slots on the right side
of the blade and disc holder. Each slot holds
one food processor disc securely, with disc
cutting blade totally protected behind a
plastic barrier. To insert a disc, hold it so
the cutting side faces left and the disc stem
connector side faces right. Grasp the disc by
placing your thumb on the edge of the disc
and your fingers under the center lock on the
stem attachment plate.
This positions the disc for correct insertion
into the holder.
WARNING: CUTTING EDGES OF FOOD
PROCESSOR DISCS ARE VERY SHARP.
ALWAYS KEEP FINGERS AWAY FROM
SHARP SIDE.
Never try to force a disc into the holder.
If inserted correctly, the disc will slide easily
into the slot. Slide the disc straight into a
slot. The disc will slip securely into place,
with its cutting blade behind the plastic
barrier. Discs will sit correctly and safely only
when inserted in this manner.