Specifications

ManualsBrandsCuisinart ManualsBlenderCSB-79C

SHARP SIDE

CHOPPER/GRINDER ATTACHMENT

1. Place the chopping/grinding blade into centre of the work

bowl over metal blade shaft.

2. Place the motor body housing with cover on top of the work

bowl and rotate counterclockwise to lock into place.

3. Plug the power cord of the hand blender into an electrical

outlet.

WHISK ATTACHMENT

1. Align the motor body

housing with the assembled

whisk attachment and push

the pieces together until you

hear and feel them click

together. It may be helpful to

press the release button

when assembling.

Note: Whisk and whisk

gearbox are detachable

from one another.

REVERSIBLE BLADE

The Cuisinart

Smart Stick

Two Speed Hand Blender chopper/

grinder attachment is equipped with a reversible blade. This blade is

sharp on one side and blunt on the other. The blade is attached to a

plastic ring that slides over the plastic blade sheath, so it can be

easily turned over to select the appropriate blade. To reverse the

blade, see detailed instructions below. Also see Frequent Uses for

Chopper/Grinder (page 14).

Assemble the parts.

1. Place the work bowl on a flat, dry, stable surface. It should

be close to an electrical outlet of the same voltage as stated

on the rating plate on the hand blender.

2. The metal blade assembly shaft (A) is

attached to the bottom of the work bowl.

If not already in place, slide the fully

assembled blade assembly (B) over the

top of the metal blade assembly shaft.

2a. Put together the blade assembly if not assembled:

Very carefully connect the blade ring (C) to the plastic blade

sheath (D). Line up the blade ring opening with the plastic

sheath. There are notches (E) on opposite sides of the interior

of the hub. These fit over ridges on the sides of the plastic

blade sheath (G). Let the blade ring slide to the bottom of the

plastic sheath. HOLD THE BLADE RING BY THE CENTRAL

HUB HOLDING RIBS (grips) (F) ONLY. DO NOT TOUCH THE

RAZOR-SHARP BLADES. Pick up the blade ring by its hub

holding ribs (grips) and turn it very slightly clockwise. This

locks it in place on the plastic blade sheath and prevents it

from sliding up during processing.

Note these important features of the blade ring. The blade ring can

be placed over the plastic blade sheath in two different ways:

If you hold it this way (A), you will see the word “Sharp” on the

blade. Assemble the blade this side up to use the sharp edge.