Blender User Manual

12
WALL-MOUNT OPTION
Separate the two plastic storage stand pieces. You will need only one for
wall mount. (See diagram above)
When selecting a mounting location, be sure to leave enough room above
the storage stand for your hand to remove the Cuisinart
®
Smart Stick
PLUS
®
Cordless Rechargeable Hand Blender. Also be sure to leave enough
room below the stand to allow the appliance to hang freely.
You will need to drill two holes 2
2
/
3
" apart from each other, measured from
the center of each hole. To assist in proper location of holes for the
mounting screws, remove the wall mount template from this instruction
book (page 13). Place the template over the back of the wall unit, aligning
the outline of the template with the wall bracket. When you have done this,
place the template and wall bracket against the wall in the desired location.
Remove the wall bracket, leaving the template in place. Mark the wall with a
pencil in the locations
indicated for screw holes by the template. Remove
the template.
With a drill, make a
3
/
16
" starter hole for each screw. Place the plastic anchor
in each hole. Push completely into the hole with fingers, or tap in gently
with a hammer. Screw a mounting screw into each hole, leaving
1
/
8
" to ¼" of
the head and screw exposed.
Position the two mounting holes of the wall bracket over the screw heads,
and slide wall bracket down the wall until the bracket is resting against the
screw head, and will not slide any further. If the wall bracket feels too loose
against the wall, remove bracket, put screws further into wall, and replace
bracket.
Place the assembled hand blender into the wall bracket. The unit will hang
from the bracket, held in place by the motor body width.
The charger handle can be attached to the motor body when you store the
unit. This is especially helpful when you want the hand blender close at
hand during a period of heavy use. At other times, keep the charger handle
plugged into the electrical socket to assure the battery is always 100%
charged.