Use and Care Manual

CARE AND MAINTENANCE

• Check heater immediately if any of the following conditions exist:

a. The smell of gas in conjunction with extreme yellow tipping of burner ﬂames.

b. Heater does not reach proper temperature.

c. Heater’s glow is excessively uneven.

d. Burner makes popping noises during use.

Note: A slight pop is normal when burner is extinguished.

• Carbon deposits may create a ﬁre hazard. Keep dome and emitter clean at all times.

• Do not clean heater with combustible or corrosive cleaners. Use warm, soapy water.

• This heater should be thoroughly cleaned on a regular basis.

• After a period of storage and/or no use, check for leaks, burner obstructions and inspect for

any abrasion, wear, cuts to the hose.

Cleaning

• Wipe surfaces clean with mild dish detergent or baking soda.

• For stubborn surfaces use a citrus-based degreaser and a nylon scrubbing brush.

• Rinse clean with water.

Note: While cleaning the unit, be sure to keep the area around the burner and pilot assembly

dry at all times. Do not submerge the control valve assembly. If the gas control is submerged in

water, do NOT use it. It must be replaced.

Maintenance

• Keep exterior surfaces clean.

• Air ﬂow must be unobstructed. Keep controls, burner and circulating air passageways clean.

Signs of possible blockage include:

Gas odor with extreme yellow tipping of ﬂame.

Heater does NOT reach the desired temperature.

Heater glow is excessively uneven.

Heater makes popping noises.

Note: In a salt-air environment (such as near an ocean) corrosion occurs more quickly than

normal. Frequently check for corroded areas and repair them promptly.

Storage

Between uses or during periods of extended inactivity:

• Turn control knob to “OFF”.

• Disconnect LP cylinder and move to a secure, well-location outdoors.

• Store heater upright in an area sheltered from direct contact with inclement weather (such as

rain, sleet, hail, snow, dust and debris).

Note: Never leave LP gas tank exposed to direct sunlight or excessive heat.

• If desired, use cover (Sold Separately , Model Number CHC-501) to protect the heater and

help prevent buildup in air passages.

CAUTION: Wait until heater is cool before covering.

CAUTION: Always allow heater to cool before attempting service.