Use and Care Manual

SAFETY CHECK
OPERATION INSTRUCTIONS
15
Checking for Leaks
Your table top patio heater has been checked at all factory
connections for leakage. When using a conversion hose (not
included) and a 20 lb. tank, check the connection at the gas hose/
regulator/cylinder:
a. Make leakage solution by mixing 1part liquid dish soap and 3 part
water.
b. Spoon or brush several drops (or use squirt bottle) of the solution
onto the gas hose/regulator and regulator/cylinder and hose
connection.
c. Turn on gas cylinder valve. Inspect the connections and look for
bubbles.
d. If no bubbles appear, the connection is safe.
e. If bubbles appear, there is leakage. If a leak is present, remove the gas cylinder immediately, tighten any
leaking fittings, replace the gas cylinder, and recheck.
f. If bubbles appear, there is leakage. If a leak is present, remove the gas cylinder immediately, tighten any
leaking fittings, replace the gas cylinder, and recheck.
• Periodically check the whole gas system for leaks.
• Immediately check for leaks if an odor of gas is detected.
• Extinguish all open flames during testing or when an odor of gas is detected.
• Never smoke while performing a leak test.
• If you cannot stop a leak, unscrew and remove the cylinder from the heater.
• Check the heater with a full propane cylinder. Do not use the heater until you have performed a
leak test on all the connections and verified that your unit does not leak.
• Use only manufactured recommended parts. Substitution may void the warranty.
This appliance should only be used in a well-ventilated space and should not be used inside a building,
garage or any other enclosed area.
1. This portable heater is intended for outdoor use only. Always
ensure that adequate fresh air ventilation is provided.
2. Always maintain proper clearance to combustible materials.
3. Never operate the heater in an explosive atmosphere line in areas
where gasoline or other flammable liquids or vapors are stored.
4. The heater must be fixed on a strong, stable table with a minimum
height of 1300mm from the floor level.
Lighting Instructions
1. Ensure that the control knob on the burner is OFF.
2. Push the control knob in and slowly rotate to HIGH. This will
activate the built-in igniter and light the burner. Once burner is lit,
hold control knob in for 30 seconds and then release. If the burner
fails to remain lit or becomes extinguished, repeat this step. Note: If a
new tank has just been connected, please allow at least one minute
for the air in the gas pipeline to purge out through the pilot hole.
3. After the flame comes on, leave the variable control knob on LOW
for about 5 minutes, and then switch to the desired temperature.
HIGH
OFF
LOW
HIGH
OFF
LOW