Specifications

21
Cleaning & Maintenance
 CAUTION: Handle the blade assembly carefully as the blades are VERY SHARP. Do not attempt to re-
move blades from blade assembly.
 Always unplug the appliance from the mains outlet before cleaning.
 Before  rst use, and after every use, clean each part thoroughly.
 Periodically check all parts before reassembly. If any part is damaged or jar is chipped or cracked,
do not use blender.
 Remove the jar and blade assembly following ‘Instructions for use’ section B.
 Empty jar and carefully disassemble parts. Wash blade assembly, rubber seal and locking collar in warm soapy
water. Rinse and dry all parts thoroughly.
 You may wish to clean your blade assembly as follows: Squirt a small amount of washing-up liquid into
assembled jar unit. Half  ll with warm water and blend on ‘Low’ for 15 seconds. Repeat, using clean tap
water.
 Place locking collar in the upper rack of dishwasher or wash in warm water.
 Remove the blender jar lid and the measuring cap, and wash in warm, soapy water; rinse and dry thoroughly.
Do not clean lid or rubber seal in a dishwasher, they are not dishwasher proof.
 The glass jar must be washed in warm soapy water and rinsed and dried thoroughly. The glass jar can also be
placed upside down in dishwasher.
 Finally, wipe the motor base clean with a damp cloth to remove any residue, and dry thoroughly. Do not use
abrasive cleaners on the housing base. Apply any cleaning agent to the cloth, not the base.
 Never submerge the motor base in water or other liquid, or place in a dishwasher.