Instructions / Assembly

40
PART 3 - HELP & SUPPORT
If you suspect your camera is not funconing
correctly follow these steps.
Press MODE unl TESTS is displayed. Press MORE to
view the available test features. Press UP to run a
test.
WALK - (Detector Test) If you suspect the camera is
not detecng animals place the camera in WALK.
Walk in front of the camera. The red LED will
illuminate if it detects you.
RESET - Press UP to reset the camera to factory
defaults. It is good pracce to reset a camera if you
think the camera is not funconing correctly.
BATTERY LEVEL - Displays the voltage level of the
baeries. If LOW or DEAD is displayed you should
replace the baeries. Press UP to display Baery
Images (BI) and Baery Days (BD).
BATTERY LOAD - Tests the current capacity of the
baery. Press UP to run the test which will display the
% of current capacity in the baery. This test is more
accurate than the Baery Level voltage test. If the
reading is below 50% you should replace the