Owner`s manual

a) If [Camera Delay] is not displayed on the
LCD, press numerous times until
[Camera Delay] is displayed (figure 11).
b) Press or to change the setting.
c) The range is 1 minute to 60 minutes.
2)
Set Date (figure 12)
a) If
[Set Date] is not displayed on the LCD,
press numerous times until
[Set Date] is
displayed.
b) Press to advance the month.
c) Press to advance the day.
3)
Set Year (figure 13)
a) If
[Set Year] is not displayed on the LCD,
press
(S) numerous times until [Set Year] is
displayed.
b) Press to reduce the year.
c) Press to advance the year.
4)
Set Time (figure 14)
a) If
[Set Time] is not displayed on the LCD,
press numerous times until
[Set Time]
is displayed.
b) Press to advance the hour. The AM/PM
indicator will change to indicate an AM or
PM hour.
c) Press to advance the minutes.
Figure 11
Figure 12
Figure 14
Figure 13
11
Set Year
2006
Set Time
11:16 AM
Set Date
4/05
Delay
01 min
MOTION / HEAT DETECTOR SENSITIVITY LEVEL
The sensitivity of Cuddeback's motion/heat sensor
can be changed.
1) Press numerous times until
[Utilities? C =
Yes]
is displayed.
2) Press
[View Quality] is displayed.
3) Press
[Sense Level] is displayed (figure 74).
4) Press or to change the setting. Select
one of the following settings.
a) Low
b) Standard
c) High. We recommend using this setting.
d) Auto will program Cuddeback to automatical-
ly change the sensitivity level for day or night
activity. This limits Cuddeback's detection
range to the distance of the camera's flash.
TIP - Detection performance
varies with air temperatures and
animal size. If you photograph
more small animals than you
would like, or see more blank
images, lower the sensitivity.
Blank images are typically caused
by very fast moving animals and
birds. Setting a sensitivity level of
low or standard will reduce these
occurrences. However, because a
digital image does not cost any-
thing, we recommend using the
high setting and allow for the few
blank images that may occur.
TAKING A PICTURE MANUALLY
You can manually take a picture with Cuddeback.
1) Press until
[Utilities? C = Yes] is displayed.
2) Press . The display will prompt
[View Quality].
3) Press two times.
[Take Picture? C = Yes] is
displayed. (figure 75)
4) Press to take a picture. Press to continue
without taking a picture.
5) If you press the display will show
[Pending]
and the red LED will flash. In about 20 seconds the
camera will record an image. (figure 76)
42
Sense Leve
High
Figure 74
Take Pictu
C = Yes
Figure 75
Take Pictu
Pending
Figure 76