User Manual Cuddeback, Simple, Camera

Cuddeback Advanced User Interface Quick Set-Up
A quick guide to seng up your Cuddeback camera that operates on our
Advanced User Interface.
920-347-3810
www.cuddeback.com
[e-mail]
Supplies Needed to Begin Set-Up
1. Required amount of baeries
2. Full-size SD card 2-32GB. We recommend the SanDisk brand
Advanced User Interface - Geng Started
1. Set the Time - Press the Mode buon to Clock. This should
show you the clock. Use the Up/Down arrows to adjust hour
seng. Press the More buon to go to minute seng. Use
the Up/Down arrows to change the minute seng.
2. Set the Date - Press the More buon aer seng me to
move to the date. Press the Up arrow to get to the month. Use the Up/Down arrows to change the month. Press the
More buon to move to the day. Use the Up/Down arrows to change the day. Press the More buon to move to
the year. Use the Up/Down Arrows to change the year.
Advanced User Interface - Recommended Sengs
The following explains the recommended sengs for quick-set up of Cuddeback cameras.
There are a few opons under Commands that you can change, but we recommend leaving them set to default. Leaving
them on default is the recommended opon.
Press Mode to Sengs, which should ash EZ Mode and is the recommended mode to use for quick set-up.
Press More and you will see the camera Delay, which is set to 15 seconds and the recommended seng for quick set-up.
The Delay dictates how fast the camera will reload to take an image aer it has already been triggered by heat/moon and
taken an image.
Press More and you will see the Video seng, which is default set to OFF. We recommend leaving it to o for quick set-up.
Aer you have set the Date/Time and the camera delay. Press Mode to ARM, close the user interface door and slide the
camera onto the camera mount. The camera will count down and ARM, meaning it is ready to start taking pictures that are
triggered by both heat/moon.