Instructions / Assembly
11
Connue to deploy all your Remote cameras in a similar
manner. When deploying a Remote it is good pracce to
enable CL LEVEL while next to a Home or Remote camera
that has been successfully deployed and armed. When a
CL LEVEL appears on the camera begin moving to the
new locaon. This method makes it easy to monitor the
connecon status as you move about.
Press MORE to view CL LEVEL and observe the display. At
rst - - - - will be displayed to indicate no signal. Aer a
minute or 2 a number will appear that represents the
signal strength. If the strength is displayed you can ARM
and deploy the camera.
If a signal is not displayed within a few minutes you may
be too far from the HOME camera, or HOME may not be
ARMed.
IMPORTANT – CuddeLink transmission distance varies with terrain
and distance and can be from 2/10 of a mile to over a mile. Typical
range in a forest is 1/4 mile. You must use CL LEVEL to verify you
have a signal before you deploy a remote camera.
Aer a signal is received you must ARM the camera
before deploying addional remote cameras. (Press
MODE unl ARM is selected).
Signal will be displayed as GOOD or WEAK. Dashes indicate no signal is received.