Use and Care Manual

ENGLISH
35
www.cuckooworld.com
CHECK BEFORE ASKING
FOR SERVICE
If there is a problem with your cooker, check the following details before requesting service to your dealer.
Sometimes the cooker may not operate as desired if used incorrectly.
Case Check points Do the following
When the rice is not cooked.
High Pressure Cook/Turbo button is pressed?
Is there power cut while in cooking?
Press the High Pressure Cook/Turbo button once. And
check “ sign on the display.
Blackout backup power source for the Rice Cooker, see
page 24.
When the rice is not
cooked well.
Did you use the measuring cup to measure your
rice?
Did you measure proper water?
Did you clean the rice before cooking?
Did you put rice in water too long time?
Is the rice old or dry?
Refer to page 25.
Add water about half the notch and then cook.
When pea (Mixed Rice) is not
well cooked.
Is pea (Mixed Rice) too dry?
After pea (Mixed Rice) is enlarged, please cook them
according to Menu. Based on different type of pea may not
be well cooked.
Rice is too watery or stiff.
Is the menu selected correctly?
Did you properly measure water?
Did you open the lid before cooking was finished?
Selected the correct menu.
Measure the proper water.
Open the lid after cooking finished.
When the water overflows.
Did you use the measuring cup?
Did you measure proper water?
Did you open the lid before cooking was
finished?
Did you select correct menu?
Refer to page 25.
When you smell odors while
warming.
Did you close the lid?
Please check the power cord input to wall
socket.
Did it warm over 12 hours?
Is there any other substance such as rice
scoop or cold rice?
Close the lid perfectly.
Always be keeping the power on while warming.
As possible as warming time is within 12hours.
Don’t warm rice with other substance.
”, “ ”, “ signs
show up.
There is some problem on the
temperature sensor.
Please contact Customer Service center.
Warming passed time mark
blinks during keeping warm
24 hours has not passed yet after keeping
warm
This function alarms if the rice remained warm
for more than 24 hours.
Cooking is not completed for a
long time. “
” signal will be
shown.
Did you use 220V power plug?
It represents the product is malfunction(heater is
damaged or heating volume is low ), rice is undercooked
for a long time, please turn off the
power and contact Customer Service center.
It is normal to show “ ” signal after boiling
water only for a long time.
It is Product applicable for 120V only.
Please use the power supply properly.
If “
” sign appears.
It shows on the display when pressing High Pressure
Cook/Turbo button again, or when the cooking has
finished and you’ve never turned the handle to ‘
non pressure’.
It can be solved by turning handle to ‘ non pressure’.
and then turn to ‘high pressure ’.