Instructions / Assembly

26
before use / HoW To use
Sit on the Toilet Seat
▶ Sit on the middle of the toilet
seat
Press the button
or
▶ Available to use Rear mode
▶ Available to use for 90 seconds
▶ If you press the button one more time, you can use
move mode.
Press the button (Stop)
▶ Rear mode will stop
Press the button
▶ Available to use for 3
minutes
▶ If you clean with the toilet
paper, it has excellent drying
effect.
2
Connect the power Supply and open the main water
Supply valve.
▶ This product exclusively uses an AC 120V/ 60Hz.
▶ Always put the Power Plug in a grounded Power Outlet exclusively for
AC 120V/60Hz.
▶ The bidet works normally only when the power is connected and water is
supplied.
Do not perch on an outer edge of the Toilet Seat, but always sit on the center.
▶ If you move your buttocks or cross your legs while using the product, the product may stop operation.
▶ If you install an auxiliary seat for infants on the ELECTRONICBIDETSEAT, the product will not work.
(The Skin Sensor will fail to detect.)
When the water pressure on the ElectronicBidetSeat is low
▶If you use the Electronic Bidet Seat at the same time as you flush the toilet after relieving yourself,
the water pressure may decrease.
▶If your region has a low water pressure, the Electronic Bidet Seat may not work.
(If the water pressure is 0.1 MPa (1.0 bar) or lower, the Electronic Bidet Seat may not work.)
1
2
3
Checklist before Use
How to use
•Toilet Seat Sensor is installed inside of toilet seat. (Refer to ❺ of 13 page “After installing the product, please check the
followings” Toilet Seat Sensor is activated if it is touched by skin of human. It will be unactivated If toilet seat is covered by
anything or unavailable to sense the skin of human.
1
3 4