Quick Start Guide

HOW TO USE NUT DISPENSER AND REMOVE BREAD FROM PAN
REMOVING BREAD
Oven mitts should be used as the bread pan and baking chamber will be hot. To remove the bread pan,
lift the handle, turn it counterclockwise to unlock, and lift the pan straight up from the base of the
chamber.
After you remove the pan, carefully shake the bread upside down until it falls out. Let the bread cool on
a wirer rack for 10 minutes before you slice it with a bread knife.
TIP: If the kneading paddle is stuck in the loaf, remove it with a hook (or kneading paddle remover).
TIP : If needed, when the paddle signal alerts, pause the unit by pressing the START/STOP button. After pausing, remove the
dough and kneading paddle,reshape the dough, and replace the bread pan. To continue, press the START/STOP button
➡
※ Be sure to install and tighten both holders correctly.
Bread maker may not function properly due to improper tightening.
Using the fruit & nut dispenser
If you wish to add nuts or seeds to your loaf, it is not recommended to dispense them into the flour at first
preparation. This may cause the nuts or seeds to lose flavor and texture due to over stirring.
The automatic dispenser function will help you add fruits, nuts, raisins, or other add-ins without waiting by
the bread maker. Pour the nuts or seeds in the dispenser, then install it below the lid. After installation,
close the lid and start the program. After approximately 30 minutes (time may differ) of baking, the nut
dispenser will operate 3 times. To ensure all contents are dispensed, the dispenser will push the bottom
cover open. The dispensing function is automatically set in menus 1-7 and 13.
퀵가이드-김상엽148X210_2017.qxp_레이아웃 1 2020. 12. 29. 오후 4:46 페이지 2