Operation Manual

CLEANING THE EXTERIOR

• Clean the Cube’s exterior with a lint free cloth and water. Dampen the cloth with water and wipe the outer surfaces of

any debris that is visible.

CLEANING THE PRINT PAD

• Submerge the Print Pad in a container lled with warm tap water. Please do not use well water; it contains certain

minerals that may make your creation difcult to remove from the Print Pad.

• Rinse pad under tap water and dry using a lint free wipe.

CLEANING THE PRINT TIP

• Using the small pliers, pull away any plastic debris away from the Print Jet tip (if

the debris is stubborn, the Print Jet may need to be heated to make the debris soft

enough to remove).

CLEANING THE TOUCHSCREEN

WARNING: PRINT JET NOZZLE TIP BECOMES EXTREMELY HOT DURING

SET-UP AND OPERATION. DO NOT TOUCH NOZZLE.

• Wipe the touchscreen with the soft, lint-free cloth. Do not spray cleaners on the

touchscreen.

4 AMP FUSE REPLACEMENT

CAUTION: Before replacing the fuse, switch Cube’s power off and unplug

power cord.

1. 4 Amp, 250 V fast blow fuse is located on the back left side of your Cube.

2. Using a at screwdriver, turn screwdriver counterclockwise to remove fuse from the

fuse holder.

3. Using a at screwdriver, turn screwdriver clockwise to install new fuse into the fuse

holder. After new fuse is installed, plug power cord into outlet and switch power on.

23 MAINTAINING YOUR CUBE