Operation Manual

Do not change color of material or cartridge during printing; doing so may damage the Cube.

1. After being instructed by the touchscreen, pull Cube Tube away from top of Print Jet. Do not pull the material out until

the touch screen instructs you to do so.

2. Pull material out of Print Jet and press Next.

NOTE: After the material is pulled out from the print jet, material debris may be visible at the print tip that could

clog the tip. Using the unclog tool, insert the tool’s point into the Print Jet; if debris is present, it will protrude

from the print tip.

3. Tilt cartridge down to clear Cube feeder and remove cartridge from cube; remove the Cube Tube from material. Replace

thumb screw into cartridge to hold the unused material in place. Refer to Step 18: Material Cartridge Installation for

instructions on how to install your new cartridge.

20 REPLACING MATERIAL CARTRIDGE