Operation Manual

PRINTING YOUR FIRST CREATION (continued)
PRINTING FROM THE USB MEMORY STICK
1. If you are using your USB Memory Stick to download your Cube le, please install the USB Memory Stick into the
USB port on your computer. Open the le folder where your Cube le is located and save it on the USB Memory Stick.
Remove memory stick and install it into the Cube’s USB port.
2. Tap Print on the touchscreen and use left or right arrows until you see your Cube le displayed.
3. Tap on your .cube le; the print touchscreen will
appear showing the total time it will take to print
your creation and the time left to complete it during
printing. It also shows the maximum height of your
creation and the current height while printing.
4. The Cube will begin the heating process that
will take a few minutes. During the heating
process, the print tip and the Print Pad will reach
the temperatures that have been preset by the
manufacturer. Once these temperatures are
reached, your creation will begin to print. Once the
creation is nished printing, your touch screen will
display Print Finished, press the check box to
conrm. Wait until the Print Pad is completely cool
before removing your print.
WARNING: PRINT JET NOZZLE TIP BECOMES EXTREMELY HOT DURING SET-UP AND OPERATION. DO
NOT TOUCH NOZZLE.
Do not change color of material or cartridge during printing; doing so may damage the Cube.
ABORTING YOUR PRINT
To abort your creation during warm up or printing, nger tap the STOP button on touchscreen. The next screen will read Are
you sure you want to abort the print? Finger tap the check box to abort or tap the X box to cancel. Wait until the print
tip completely cools before touching.
!
25