Operation Manual

NOTE: CubeStick must be applied to the Print Pad every time you start a new creation.
CAUTION: Do not use any adhesive other than the CubeStick. Doing so can damage your print tip and the
Print Pad. Make sure you use the 2nd generation CubeStick for your 2nd generation Cube.
WARNING: APPLY ADHESIVE JUST PRIOR TO STARTING A PRINT. ADHESIVE WILL DRY IF YOU WAIT TO
START A PRINT AFTER APPLICATION. ADHESIVE SHOULD STILL BE WET AT START OF PRINT.
1. Find the CubeStick in the original packaging.
2. Remove Print Pad from the Cube. Apply a thin, even coat of adhesive on the entire
top surface of the Print Pad. (Don’t over-apply!) Check the Print Pad after applying
the adhesive to make sure there aren’t any gaps where the adhesive was not
applied. If you nd any gaps, apply adhesive to those areas. Never put glue on side
with magnet.
3. Replace CubeStick cap after use.
4. Place Print Pad on the Print Pad platform.
!
!
23
18 PRINTING PREPARATION