Operation Manual

Print Pad
USB Cable**
Cube Tube
USB Stick
Quick Start Guide
CubeStick™
Unclog Tool***
The Cube
Power Supply
Material Cartridge*
Power Cord
cubify.com
*Neon green included **For downloading rmware ***For unclogging lament in Print Jet
SETTING UP YOUR CUBE
1. Remove the white plastic inserts from each side of the box by pinching the tabs in and bending the inserts out. Pull to
remove both from the box. Lift top of carton up and remove.
2. Lift foam from the top of Cube. Remove foam from the midsection and below the plate by gently pulling out from the
front. Remove Cube from box.
3. Lift foam that Cube was sitting on to access power supply and other accessories.
4. Remove the Print Pad from the foam under the Cube and set it aside.
5. Plug round connector of power supply into the back of the Cube.
6. Plug power cord into power supply, then into outlet or power strip.
14
6 UNPACKING AND SETTING UP YOUR CUBE