User Manual

Page 7 / 7

www.3dcubicon.com

▣ FCC statement

FCC Modular Usage Statement

 

Note 1: Any modifications made to the module will void the Grant of Certification, this module is

limited to OEM installation only and must not be sold to end-users, end-user shall have no manual

instructions to remove or install the device, only software or operating procedure shall be placed in

the end-user operating manual of final products.



Note 2: Host product manufacturers must provide in their user manual the required RF exposure

information for usage of this module. Host product manufacturers must use the following

RF exposure statement in their user manual “This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. End users must follow the specific operating

instructions for satisfying RF exposure compliance. The antenna used for this transmitter must not

transmit simultaneously with any other antenna or transmitter, except in accordance with FCC

multi-transmitter product procedures”



Note 3: Additional testing and certification may be necessary when multiple modules are used.



Note 4: The module may be operated only with the integral PCB pattern antenna with which it is

authorized. 

Note 5: To ensure compliance with all non-transmitter functions the host manufacturer is responsible

for ensuring compliance with the module(s) installed and fully operational. For example, if a host was

previously authorized as an unintentional radiator under the Supplier’s Declaration of Conformity

procedure without a transmitter certified module and a module is added, the host manufacturer is

responsible for ensuring that the after the module is installed and operational the host continues to

be compliant with the part 15B unintentional radiator requirements. Since this may depend on the

details of how the module is integrated with the host, the manufacturer shall provide guidance to

the host manufacturer for compliance with the part 15B requirements. 

Note 6: The FCC ID label on the final system must be labeled with “Contains FCC ID: 2AYSO-F803-0049” 

Note 7: The FCC rule/s for this module are CFR 47 Part 15 Subpart C 15.225. 

Note 8: This modular transmitter is only FCC authorized for the specific rule parts listed on its grant.

The host product manufacturer is responsible to any other FCC rules that apply to the host not

covered by the modular.