User Manual

Page 6 / 7
www.3dcubicon.com
▣ CE statement
This device can be operated in at least one Member State without infringing applicable requirements
on the use of radio spectrum."
- RF Range: 13.56MHz (RFID)
▣ FCC statement
Certification and Safety Approvals FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment on
and off, the user is encouraged to try to correct the interference by one or more of the following
measures: -Reorient or relocate the receiving antennae -Increase the separation between the
equipment and the receiver -Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End users must follow the specific operating instructions for satisfying
RF exposure compliance. The antenna used for this transmitter must not transmit simultaneously
with any other antenna or transmitter, except in accordance with FCC multi-transmitter product
procedures