User's Manual

CubiSens
TM
TS100 User Manual
v1.7
© 2020 CubeWorks. All rights reserved. Page 8 / 15
6. In the new window that opens
click on text “Internet Protocol
Version 4(TCP/IPv4)” to select that
line. Be careful not to click on any
checkboxes. With “Internet
Protocol Version 4(TCP/IPv4)”
selected click on the button
“Properties”.
7. Choose “Use the following IP
address:” and set the IP address to
192.168.10.1. The subnet mask
should automatically set itself to
255.255.255.0, but if not then set it
to that value. Verify that the
settings are as follows, then click
“OK”.
8. Click “OK” in the ethernet
properties window, then close all
the windows opened during this
process.
The ethernet configuration for the
CubiSens™ Gateway is now
complete.