User's Manual

CubiSens

TS100 User Manual

v1.7

3. Starting Measurement

To command the TS100 to start measuring temperature with a desired measurement interval:

1. Place the TS100 on the optical programmer.

2. Select the tab “Control” in the TS100 GUI.

3. Set the measurement interval.

4. Click the “Start Measurement” button.

5. After 3-4 seconds, the TS100 will reply with a “Measurement Started” message, the current

battery state, and starts measuring at the set interval.

6. The measured data will be displayed as a “Check-in” message from the particular TS100 unit,

identified by its “Chip ID”.

Note: The TS100 will start measuring temperature values until the user stops it using optical

communication. Refer to the TS100 Technical Datasheet for details on battery life.

4. Stopping Measurement

1. Place the TS100 on the optical programmer.

2. Click on “Stop Operation” to stop ongoing measurement operation and the TS100 will report its

current battery state.

Note: This command can also be used when the TS100 is not in measurement mode, for instance, to check

what the battery state is or to identify its Chip ID.

Figure 8: Starting & Stopping Measurement