User's Manual

CubiSens
TM
TS100 User Manual
v1.7
© 2020 CubeWorks. All rights reserved. Page 10 / 15
5. The green blinking status light next to
the IP address of the gateway indicates
connection status to the gateway.
6. The opening screen shows the settings.
The COM Port of the Optical Programmer
must be selected by clicking on the Serial
Port selection dropdown menu.
Note: If multiple ports are available,
disconnect the micro USB cable from the
Optical Programmer, select “Rescan Ports”
from the selection box, and see which port
disappears. Then reconnect the USB cable
to the Optical Programmer, select “Rescan
Ports” from the selection box, and see
which new port is available. Select the
port that appears.
7. The GUI is now ready to be used.
Note: The GOC_DELAY and GOC_SPEED
values will be automatically filled with
suitable settings, and do not need to be
adjusted.