User's Manual

CubiSens
TM
N-Series AH100 User Manual
Updated April 2019
Page 8 / 11
To start Radio Test mode:
1. Place AH100 sensor on the Optical Programmer, face down
2. Go to “Action” tab in the GUI
3. Enter the desired wakeup interval between radio packets
4. Press the “Start Radio Test” button
4. Stopping Sensor Operation
To stop AH100 sensor operation or radio test operation:
1. Place AH100 sensor on the optical programmer, face down
2. Press “Stop Operation” button
3. A “Operation Stopped” packet will be transmitted by the AH100 unit
4. AH100 is now ready for configuration or starting another operation
Important Note: If any of the buttons on “Configuration” or “Debug” tabs are pressed while the sensor is
placed on the optical programmer and the sensor was in the middle of an operation (motion or light
change sensing), the sensor operation will be stopped as well.
Starting Radio Test Mode
Stopping AH100 Sensing Operation / Radio Test