User's Manual

CubiSens
TM
N-Series AH100 User Manual
Updated April 2019
Page 4 / 11
3. Connecting Devices (Maintenance Mode)
For maintenance and debugging, please follow the steps below to connect the gateway, antenna, monitor,
keyboard, and optical programmer:
1. Connect the antenna to the ANT1 port
2. Connect the ethernet cable to ETH1 port
3. Connect the monitor to the CubiSens Gateway using miniDP-HDMI cable
4. Connect monitor’s power cable
5. Connect the wireless keyboard’s dongle to USB1 port
6. Connect Optical Programmer to the USB2 or USB3 port
7. Plug in the power adapter to Gateway’s DC2 port
4. Unused Ports
The following ports should not be connected at any time.
Completed setup for maintenance / debugging
Ports shown in red box should not be connected at any time