Users Manual

6
4. System Operation
4.1 System operation
System Status
BSD Indicators
WTA Indicator
Audible Warning
System Startup/Restart
Illuminate for 3sec
Yellow & red lights
flash alternatively
A long beep for 3sec
System turn on
(Operation via the power button)
Flash twice
Red light flashes twice
2 short beeps
System turn off
(ACC OFF)
No
No
No
Left sensor Failure
Light up
No
DO RE MI sound
Right sensor Failure / System Error
Light up
Yellow lights up
DO RE MI sound
※ If the troubleshooting is not ruled out, the system will issue an alarm every five minutes.
Indicators brightness adjustment:
1. When the system is turned on and the vehicle speed is 0km/h(0mph), a continuous short press of the system button
twice will trigger the indicators brightness to change once. This operation allows you to adjust three brightness
adjustments of the indicators. The description is as follows: A continuous short press of the system switch twice for
the first time will cause all indicators to flash 3 times in high brightness, a second continuous short press of the
system switch will cause all indicators to flash 3 times in mid-brightness, and a third continuous short press of the
system switch will allow all indicators to flash 3 times in low brightness. If you stop the operating system switch
halfway, the indicators will be displayed in a previously set brightness.
Note: When adjusting the brightness, the wide turn assist indicator will only light up in red.
2. Once the system’s power is cut off, the indicators brightness will resume its installation setup brightness. To adjust
the brightness of the indicators, you need to repeat operation 1.
3. The blind spot sensors will continue to detect during the operation setting. If a vehicle enters a warning zone at this
time, the indicator may first display a desired brightness before giving the warning.