Product Manual

8
ASSEMBLY
2. Install the seat onto the seat pan (a) using
hardware provided.
a. For a Knob Adjust seat insert bolts (b) in the rear holes
and lock washer (c) and knobs (d) in the front. Tighten
securely. See Figure 5.
(b)
(
b)
(c)
(c)
(d)
(a)
(d)
Figure 5
b. For a Lever Adjust seat use flange lock nuts (a) and flat
washers (b). See Figure 6.
(a)
(a)
(b)
(b)
(c)
(a)
(a)
Figure 6
3. If necessary, securely connect the seat switch wiring harness
(a) to the seat switch (b). See Figure 7. Secure excess wire
away from pinch points before continuing.
(a)
(b)
(a)
(b)
Figure 7
NOTE: Tractor will not operate without the seat switch wiring
harness connected.
Position Lapbar Drive Control Levers
The lapbar drive control levers can be adjusted up/down and
forward/backward for the operator’s comfort. Three height
positions are available and/or levers can be rotated forward or
rearward using the knob.
To adjust the lapbar drive control lever height, proceed
as follows:
1. Remove the two carriage screws (a) and two flange lock nuts
(b) that secure the lapbar drive control lever (c) to the upper
handle adjuster (d). See Figure 8.
NOTE: The multi-tool (if equipped) can be used to make
thisadjustment.
2. Move the lapbar drive control lever into one of three available
heights and secure in place with the carriage screws and
flange lock nuts. See Figure 8.
(b)
(b)
(a)
(a)
(c)
(d)
Figure 8
To adjust the lapbar drive control levers forward/rearward,
proceed as follows:
1. Rotate the knob (a) counter-clockwise to loosen the knob (a).
See Figure 9 on page 9.
2. Lift and rotate the lapbar drive control lever into the
desiredposition.
3. Rotate the knob clockwise to secure the lapbar drive control
lever into position. See Figure 9 on page 9.
4. If the lapbars do not line up after making the knob
adjustment, loosen nuts (b), align lapbars and re-tighten
nuts. Once this fine adjustment is made, the lapbars will align
when using the knob adjustment. See Figure 8.