Instruction Manual

14 ZT-2800
®
/ZT-3100™/ZT-3400™
Refer to Figure 8
Disassembly
1. Remove all items previously discussed in
their recommended order.
2. Remove the RTN control arm kit (211) by
rst removing the spring (147) and Torx
head screw (46). The remaining members
of the assembly can be removed as a single
item – washer (146), unidirectional scissor
arm kit (145), and the control arm (44).
3. Remove the Allen head screw (142), washer
(45), neutral arm (141) and spacer (140).
NOTE: Onlyremovetheseal(41)ifdamaged
orworn.ThesealisnotpartoftheRTN
control arm kit (211), and cannot be
servicedseparately.Referto“SealKit”
intheItemsListonpages43or45.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 21 for the required torque
values.
3. Refer to the RTN adjustments on page
13.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
RETURN TO NEUTRAL ASSEMBLY
Figure 8, Return to Neutral Assembly
Re f e R t o “Re t u R n t o ne u t R a l Se t t i n g ”
on Pa g e 13.
211
46
146
145
14244
141
45
140
147
41