Owner's manual

EZT
®
9
FLUID CHANGE PROCEDURE
This transaxle is factory lled, sealed and does
not require oil maintenance. However, in the
event of oil contamination or degradation, oil
addition or change may alleviate certain per-
formance problems.
1. Remove the transaxle from the vehicle.
NOTE: If removing the wheel from the
transaxle, do so by removing the four (4)
lug nuts. Do not remove the axle/hub nut.
2. Clean the oil ll port area of any debris.
3. Remove the oil ll port tting.
4. Position the transaxle so the oil will drain
completely out of the housing.
5. Fill the transaxle at the oil ll port according
to Figure 4.
6. Install the oil ll port tting.
7. Purging will be required. Refer to the purging
procedures on Page 10.
8. Recheck the uid level once the unit has
been operated for approximately 1 min-
ute.
Table 4. Fluid Volumes for the EZT
®
Fluid Description
20W50 engine oil
Volume
52.4 . oz. (1550 ml) to 55.8 . oz. (1650 ml)
FLUID CHANGE
Figure 4. Fluid Level and Fill Port
TOP OF FILL PORT
OIL LEVEL
0.75” - 1.50” (19-38mm) depth
at 50°-100°F (10°-38°C)