Instruction Manual

Steering

14. Fill the lower housing with 12 oz. of 737-0300A Duri-

grease. See Figure 6.56.

15. Install the steering rack and bushings.

See Figure 6.57.

NOTE: The rack must be centered. When centered, the

rack will measure 1.7” from the shoulder to the

housing.

See Figure 6.57. inset

IMPORTANT: Before proceeding, test fit the input shaft

into the ball bearings for the cover. The input shaft

needs to have a slip fit. If it is too tight, clean the

shaft with some emery cloth.

16. Install the input shaft so that it is centered with the

hole in the sector gear and the center of the void for

the wear block.

See Figure 6.58.

Figure 6.56

Figure 6.57

Figure 6.58

Input shaft