User guide

T2
®
21
RETURN TO NEUTRAL/ROS ASSEMBLY OPTION
3. Install the control arm (160).
4. Install the RTN scissor arm (164), washer
(163) and Torx head screw (41). Refer to
torque chart on page 15.
5. Install the switch retainer over the neutral
arm tab. Place the rivet through the switch
retainer and neutral arm.
6. Install the RTN spring (167).
7. Press down on the switch retainer tab to bias
it. Ensure that the rivet is seated. Then set
the rivet using a rivet gun.
8. Refer to page 12 for adjusting the RTN as-
sembly.
NOTE: After installing the transaxle on the
vehicle be sure the operator presence
system and the reverse operation
system (ROS) are working properly.
Refer to the operations and mainte-
nance sections in the vehicle owner’s
manual.
Refer to Figure 13
Disassembly
1. Remove all items previously discussed in
their recommended order.
2. Remove the spring (167).
3. Remove the Torx head screw (41), discard,
and the washer (163).
4. Remove the scissor arm (164), and the RTN
control arm (160).
5. Remove the Hex ange head screw (162),
the bushing (166) and the RTN neutral arm
(165).
Inspection
1. Inspect all parts for wear or damage. Re-
place if necessary.
Assembly
1. Install the neutral arm (165).
2. Install the bushing (166) and the hex head
screw (162).
160
164
163
41
162
166
167
165
Figure 13, Return to Neutral/ROS Assembly
Actuator clip
RCS switch
Switch retainer