Engine Service Manual

46
Disassembly/Inspection and Service
KohlerEngines.com 14 690 10 Rev. --
4. Disconnect governor linkage and linkage spring from
carburetor.
5. Remove carburetor.
6. Remove nuts securing arm assembly to muffl er.
Second nut is located behind arm assembly base
securing it to top of muffl er.
7. Remove arm assembly from muffl er.
Control Components
H
D
E
F
C
B
A
G
A
Flywheel Brake
Spring
B
Fixed Speed Control
Bracket
C Linkage Spring D Governor Lever
E Governor Spring F Throttle Linkage
G Screw H Nut
Disconnect Governor Spring
Disconnect governor spring from speed control bracket.
Remove Speed Control Bracket
NOTE: Fuel hose connecting carburetor and fuel tank is
held in place by a plastic ring(s), mounted on back
of speed control bracket (except for engines
equipped with fuel pump). If bracket is removed
from crankcase, it will remain attached to fuel hose.
Should replacement of speed bracket be required,
disconnect fuel line from fuel fi lter or carburetor
and slide bracket off hose. Do not disconnect fuel
hose from fuel tank.
Remove screws securing speed control bracket.
Remove Governor Lever
Loosen governor lever nut and slide lever off governor
shaft.
Flywheel/Ignition/Fuel Tank Components
B
A
I
K
F
G
H
C
D
E
J
A Flywheel Nut B Drive Cup
C Fan D Flywheel
E Ignition Module Stud F Ignition Module
G
Electric Starter (if
equipped)
H Fuel Tank
I
Flywheel Brake
Spring (if equipped)
J
Two-Piece Breather
Filter
K
One-Piece Breather
Filter
Remove Fuel Tank
1. Ensure fuel tank is empty.
2. Detach fuel tank from crankcase by removing screw.
3. Remove studs securing top of fuel tank and lift off
tank.