Engine Service Manual

45
Disassembly/Inspection and Service
14 690 10 Rev. -- KohlerEngines.com
3. Remove nuts securing fuel pump bracket to engine.
Remove fuel pump bracket, fuel pump, fuel lines
from engine. On engines equipped with a fuel pump,
top nut that secure fuel pump bracket also secures
speed control assembly bracket to stud in
crankcase.
Carburetor Components
Remove Carburetor with Standard Choke (if equipped)
A
E
D
B
C
A Carburetor Stud(s) B
Gasket and Spacer
Kit
C
Gasket and Heat
Shield Kit
D Linkage
E Carburetor
NOTE: Ensure fuel tank is empty by running engine until
it stops, and is completely out of fuel.
1. Squeeze hose clamp and slide it and fuel line off
carburetor.
2. Slide carburetor to end of intake studs.
3. Turn throttle lever clockwise until it stops. Gently
push rod and spring linkages up to disconnect them
from throttle lever.
4. Rotate carburetor until choke linkage can be
disconnected from carburetor. If equipped.
5. Slide off carburetor heat shield, spacer, and gasket,
noting sequence.
Remove Carburetor with Auto Choke (if equipped)
B
C
H
A
B
C
A
F
E
D
G
E
F
A
H
B
C
A Nut(s) B Arm Assembly
C Linkage D Choke Linkage
E Governor Linkage F Linkage Spring
G Wire Choke Linkage H Choke Link
1. Remove screws securing arm assembly to
carburetor.
2. Disconnect fuel line.
3. Remove wire choke linkage while sliding carburetor
away from engine a couple of inches.