Manual

LTX Tractors

Belt control; tensioner and idler pulleys

NOTE: The V-idler pulleys can be removed from

below using a 1/2” wrench, with no disas

s e m b l y b e y o n d r e m o v i n g t h e c u t t i n g d e c k .

See Figure 5.35.

NOTE: Confirm that the parking brake is released

before starting work.

1. Remove the mowing deck.

2. Remove the fenders by following the steps

described in Chapter 4: Body Panels.

3. Disconnect the rod that joins the arm at the left side

of the clutch/brake shaft to the drive belt tensioner

pulley bracket.

See Figure 5.36.

• Remove and discard the cotter pin to discon-

nect the rod.

4. Disconnect the extension spring that pulls on the

bracket to tension the drive belt.

See Figure 5.37.

Figure 5.35

V-sheave

pulleys

Figure 5.36

Clutch/brake shaft Rod Bracket

Figure 5.37

Extension spring

Mounting points