Manual

LTX Tractors

7. Remove and discard the push cap that holds the

drive control pedal shaft onto the clutch/brake shaft.

See Figure 5.25.

8. Loosen the bolt that holds the left pedal shaft sup-

port strap using a 1/2” wrench. See Figure 5.26.

9. Remove the bolt that holds the right pedal shaft sup-

port strap using a 1/2” wrench.

NOTE: This will allow the pedal shaft assembly to

hang-down slightly on the right side of the

tractor.

10. Disconnect the drive control rod from the drive

pedal latch plate.

See Figure 5.27.

• Remove and discard the cotter pin.

• Unhook the drive control rod.

Figure 5.25

Tie-rod

separator

Push cap

Figure 5.26

Left pedal shaft support strap

Figure 5.27

Drive control

rod

Drive pedal

latch plate