Full Product Manual

9
ADJUSTMENTS
Adjustments
Cutting Height
There are two cutting height adjustment configurations. Refer to the section
applicable to your mower.
Single Lever
The single lever cutting height
adjustment is located above the rear
left wheel. See Figure 6.
1. Carefully pull the height
adjustment lever outward
towards wheel (mower will
tend to fall when lever is moved
outward).
2. Move lever to desired position
for a change in cutting height.
3. Release lever towards deck.
Dual Lever
The dual lever cutting height adjustment levers are located above the front and rear
left wheel. See Figure 7.
1. Carefully pull the height
adjustment lever outward
towards wheel (mower will
tend to fall when lever is
moved outward).
NOTE: The front and rear
height adjustment levers
move in the opposite
direction to adjust.
2. Move lever to desired
position for a change in
cutting height.
3. Release lever towards deck.
IMPORTANT: All wheels must be placed in the same position. For rough or uneven
lawns, move each height adjustment lever to a higher position. This will prevent you
from cutting the grass too close to the ground.
1
2
3
Lower
Higher
Figure 6
2
3
Lower
Lower
r
Higher
1
Higher
Figure 7
Handle Pitch
For convenience of operation, you
may adjust the pitch of the handle
as follows:
1. Turn the handle adjustment
levers to the unlocked
position to lift the handle.
See Figure 8.
2. Place the handle into one
of the three handle height
positions, low (a), medium
(b) or high (c), located on
the handle brackets.
3. Turn the handle adjustment
levers to the locked position
to secure the handle.
NOTE: A fourth handle height
position (d) is used for storing
the mower with the handle in the
upright position. See Figure 9.
(c)
(b)
(a)
Figure 8
(d)
Figure 9