Owner manual
Operation
5
18
General Safety
competent in its usage to operate this tractor.
familiar with the controls. The operator should be in the 
position, the speed control pedals moved to the neutral 
position and the parking brake engaged.
Keep all shields in place. Keep away from moving parts.
Look behind and down to both sides of the tractor before 
and while backing up.
walk or stand on the discharge side of the mower when 
approaches while you are operating the mower.
Avoid slopes where possible. Never operate on slopes 
dangerous operating conditions. Tractors can be rolled 
over. Always mow across slopes, never up and down 
the slope. Avoid turning downhill if possible, start at the 
bottom and work up to the top. Use extra care and go 
slowly when turning downhill. 
the speed control pedals to the neutral position, engage 
the parking brake, shut off the engine and remove the 
ignition key. Wait for all movement to stop before servicing 
or cleaning.
When operating this mower, in the forward direction, do 
not allow the speed control pedals to return to neutral on 
avoid any sudden movements of the pedals when starting 
and stopping.
pass before operating along the road.
Do not operate the tractor with the mower deck removed. 
Removal of the deck will change the balance of the tractor, 
and could contribute to a tractor rollover.
Avoid operation on traction surfaces that are unstable; use 
extreme caution if the surface is slippery. Always remove 
debris and other objects from the area to be mowed - 
debris and loose grass will reduce traction.
Mow only in daylight or good artificial light.
Watch for holes, sprinkler heads, and other hidden hazards.
Avoid dr iving too close to trees, creeks, ponds, lakes, rivers, 
ditches, sand traps, and other obstacles.
 ore turning and come to a complete stop 
before any zero turn maneuver.
If yo 
place the speed control pedals in the neutral position, 
move the throttle to slow, set the parking brake, shut off 
the engine, and take the key from the ignition switch. 
Inspect for damage. Repair the damage. Make sure the 
blades are in good condition and that the blade bolts are 
tight before restarting the engine.
Do not sto p the tractor or park the tractor over 
combustible materials such as dry grass, leaves, debris, etc.
Ke ep the mower and especially the engine and hydraulic 
components clean and free of grease, grass, and leaves to 
reduce the chance of fire and permit proper cooling.
Before Operating Your Tractor
to familiarize yourself with the operation of all the 
you operate and maintain your tractor efficiently.
2. 
4. 
it is below the operating range, add oil through the fill tube 
using a funnel to bring it up to the top of the operating 
range.
Che5.  ck the hydraulic oil level. The hydraulic oil tank is 
area around the oil tank fill neck before checking the oil 
level to prevent dirt from contaminating the oil. Remove 
Allison C-4.
6. 
NOTE: New tires are overinflated in order to properly seat 
the bead to the rim.
Check that all nuts, bolts and screws are tight.7. 
Check the tension of the deck drive belts.8. 
Remove the deck covera. 
The tension of the deck drive belts are maintained b. 
by a spring mechanism that adjusts for wear and 
stretch.










