Operator`s manual
6 se c t i O n  2 — iM p O r t a n t  sa f e  Op e r a t i O n  pr a c t i c e s
Check the blade(s) and engine mounting bolts at frequent 5. 
intervals for proper tightness. Also, visually inspect blade(s) 
for damage (e.g., excessive wear, bent, cracked). Replace 
which do not meet the original equipment specifications 
may lead to improper performance and compromise 
Mower blades are sharp. Wrap the blade or wear gloves, 6. 
and use extra caution when servicing them.
Keep all nuts, bolts, and screws tight to be sure the 7. 
equipment is in safe working condition. 
Never tamper with the safety interlock system or other 8. 
safety devices. Check their proper operation regularly.
After striking a foreign object, stop the engine, disconnect 
the spark plug wire(s) and ground against the engine. 
Thoroughly inspect the machine for any damage. Repair 
the damage before starting and operating.
Never attempt to make adjustments or repairs to the 
machine while the engine is running.
Grass catcher components and the discharge cover are  
subject to wear and damage which could expose moving 
parts or allow objects to be thrown. For safety protection, 
frequently check components and replace immediately 
original equipment specifications may lead to improper 
Do not change the engine governor settings or over-speed 
the engine. The governor controls the maximum safe 
operating speed of the engine. 
Maintain or replace safety and instruction labels, as 
necessary. 
etc. to protect the environment.
this product has an Average Useful Life of seven (7) years, 
Average Useful 
Life have the machine inspected annually by an authorized 
service dealer to ensure that all mechanical and safety 
systems are working properly and not worn excessively. 
Failure to do so can result in accidents, injuries or death.
Do not modify engine
To avoid serious injury or death, do not modify engine in any 
way. Tampering with the governor setting can lead to a runaway 
engine and cause it to operate at unsafe speeds. Never tamper 
with factory setting of engine governor.
Notice Regarding Emissions
Engines which are certified to comply with California and federal 
are certified to operate on regular unleaded gasoline, and 
may include the following emission control systems: Engine 
Modification (EM) and Three Way Catalyst (TWC) if so equipped.
Spark Arrestor
WARNING! This machine is equipped with an 
internal combustion engine and should not be used 
on or near any unimproved forest-covered, brush-
exhaust system is equipped with a spark arrester 
meeting applicable local or state laws (if any).
If a spark arrester is used, it should be maintained in 
Federal laws apply on federal lands. 
A spark arrester for the muffler is available through your 
nearest engine authorized service dealer or contact the service 










