Operator`s manual
Indicator Panel Features
Battery Indicator
Illuminates and the battery voltage is displayed briefly when the 
Illuminates to indicate the battery voltage has dropped below 
the hour meter. If this indicator and display come on during 
operation, check the battery and charging system for possible 
causes and/or contact your Cub Cadet dealer.
Oil Pressure Indicator
This warning lamp indicates low engine oil pressure. If the 
indicator comes on while the engine is running, stop the engine 
immediately and check for possible causes. Do not run the 
engine while this indicator is illuminated. Contact your Cub 
Cadet dealer to have the tractor and engine inspected.
NOTE: The oil pressure indicator may illuminate when the 
the engine is started.
PTO Engaged Indicator
Parking Brake Engaged Indicator
This indicator illuminates when the parking brake is in the 
move the parking brake to the ENGAGED position. 
This indicator also illuminates when the ignition switch is turned 
are in a position other than the fully out in neutral position. Move 
the control levers fully outward.
Throttle/Choke Control
in a given position, a uniform engine speed will be 
maintained.
forward to increase the engine speed. The 
tractor is designed to operate with the 
throttle/choke control in the fast position 
(full throttle) when the tractor is being 
driven and the mower deck is engaged.
rearward to decrease the engine speed.
When starting the engine, push the control handle fully 
After starting and warming the engine, move the control 
handle rearward until you feel it move past the choke 
detent.
FAST
SLOW
Parking Brake Engagement Lever
The parking brake engagement lever is located on the 
front/left of the seat box frame, and is used to engage the 
parking brake.
lower completely to disengage the parking brake.
NOTE: 
opened out in the neutral position when engaging the 
parking brake, the engine will stop. The parking brake 
must be placed in the engaged position when starting the 
tractor engine.
Transmission Oil Expansion Reservoir 
The transmission oil expansion reservoir is connected by hoses to 
the seat box. The function of the reservoir is to hold the natural 
expansion of transmission oil that occurs as the transmission 
Under normal operating conditions, no oil should be added 
approximately ⁄
reservoir.
NOTE: 
the reservoir may be slightly higher than the maximum due to air 
air from the lines and the oil level will settle to the maximum.
14 se c t i O n  4— cO n t r O l s  a n d  fe a t u r e s










