MSDS

Pennzoil SAE 30 Motor Oil
MSDS# 11497DA
Version 1.1
Material Safety Data Sheet
Effective Date 02/05/2014
According to OSHA Hazard Communication Standard, 29 CFR
1910.1200
5/9
Print Date 07/03/2014 000000016496
MSDS_US
short-term/splash protection we recommend the same, but
recognise that suitable gloves offering this level of protection
may not be available and in this case a lower breakthrough
time may be acceptable so long as appropriate maintenance
and replacement regimes are followed. Glove thickness is not
a good predictor of glove resistance to a chemical as it is
dependent on the exact composition of the glove material.
Glove thickness should be typically greater than 0.35 mm
depending on the glove make and model.
Eye Protection
: Wear safety glasses or full face shield if splashes are likely to
occur.
Protective Clothing
: Skin protection not ordinarily required beyond standard issue
work clothes.
Monitoring Methods
: Monitoring of the concentration of substances in the breathing
zone of workers or in the general workplace may be required to
confirm compliance with an OEL and adequacy of exposure
controls. For some substances biological monitoring may also
be appropriate. Validated exposure measurement methods
should be applied by a competent person and samples
analysed by an accredited laboratory. Examples of sources of
recommended exposure measurement methods are given
below or contact the supplier. Further national methods may be
available.
National Institute of Occupational Safety and Health (NIOSH),
USA: Manual of Analytical Methods http://www.cdc.gov/niosh/
Occupational Safety and Health Administration (OSHA), USA:
Sampling and Analytical Methods http://www.osha.gov/
Health and Safety Executive (HSE), UK: Methods for the
Determination of Hazardous Substances
http://www.hse.gov.uk/
Institut für Arbeitsschutz Deutschen Gesetzlichen
Unfallversicherung (IFA), Germany.
http://www.dguv.de/inhalt/index.jsp
L'Institut National de Recherche et de Securité, (INRS), France
http://www.inrs.fr/accueil
Environmental Exposure
Controls
: Take appropriate measures to fulfil the requirements of
relevant environmental protection legislation. Avoid
contamination of the environment by following advice given in
Chapter 6. If necessary, prevent undissolved material from
being discharged to waste water. Waste water should be
treated in a municipal or industrial waste water treatment plant
before discharge to surface water. Local guidelines on
emission limits for volatile substances must be observed for the
discharge of exhaust air containing vapour.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance : Amber. Liquid at room temperature.
Odour : Slight hydrocarbon.
pH : Not applicable.