Use and Care Manual

Fasten the threaded eyebolt onto the bail by securing it 5.
from the top with the slot head screw, flat washers and lock
nut.
Thread the eyebolt and nut removed earlier into the 6.
internally threaded tube at the end of the cable. Thread
engagement should be about ⁄. Tighten the nut against

NOTE: Do not overtighten the clutch cable. Too much
tension may cause it to break.

adjustment before operating the tiller.
7.
instructions on adjusting the clutch belt.
Control Rod
Make sure the handle assembly is in the highest position. 

Remove the hairpin clips from the control rod, leave the 2.
rubber washers on the control rod.
Insert the shorter (angled) end of the control rod through 
the indicator bracket on the shift cover and secure with the

Insert the longer end of the control rod through the hole in 4.
the gear selector handle and secure with the hairpin clip.

Adjustments
Clutch

solid object, such as a wall. With the gear selection lever


examine the belt (inside the belt cover). It should not be
turning.
Do not put your fingers under the belt
cover.
If the belt turns without bail engaged, adjust it by 2.
unthreading the internally threaded tube at the end of
the cable a few turns clockwise (when standing in the

tube.

Carefully engage the clutch by lifting the clutch control bail 4.
against the handle. The wheels should spin. If the wheels
do not spin with the tiller in forward, adjust by unthreading
the tube at the end of the cable a few turns counter-

Retighten the nut against the tube.5.
Recheck both adjustments, and readjust as necessary.6.
NOTE: A secondary cable adjustment is available if you
reach the point that additional adjustment is needed.
Remove the belt cover and move the hex nuts at the other
end of the cable towards the end of the casing. Then
readjust the hex nuts at the handle.










Hairpin


9se c t i O n 3 — as s e M b l y & se t -up