Use and Care Manual

Contents of Carton
  
  
Assembly
Unpacking Instructions
NOTE: Reference to the right or left side of the tiller is

Remove the staples, break the glue on the top flaps, or cut 
the tape at the end of the carton and peel along the top
flap to open carton.
Remove the loose parts included with the tiller (i.e., 2.

Cut the corners and lay the carton down flat.
Remove the packing materials.4.
Roll or slide the tiller out of the carton. Check the carton 5.
thoroughly for loose parts.
6.
not to bend or kink the control cable.
NOTE: This tiller is shipped without gasoline or oil in the engine.


machine.
Depth Stake
Disconnect the spark plug wire and
ground it against the engine to prevent unintended
starting.
Tip the tiller forward so that it rests on the front 
counterweight.
Unthread the T-knob from the top of the depth stake and 2.
remove the flat washer and hex bolt. Remove the hairpin

Raise the tine shield hinge flap assembly and insert the 
depth stake assembly into the slot — under the tine shield
— and up through the tine shield assembly.
Insert the clevis pin through the tine shield and depth stake 4.

Insert a hex bolt into the top hole of the depth stake 5.


Tip the tiller back down so that it rests on the tines.6.

Stake

Pin





Assembly & Set-Up
3
7