Use and Care Manual

Starting the Engine
Read, understand, and follow all
instructions and warnings on the machine and in
this manual before operating.
NOTE: When pushing the tiller with the engine off, you will hear a
ratcheting sound or gear noise; this is normal.

the tiller while the engine is running or being
started.

2.

position.


(2) seconds between each push.
NOTE: A warm engine may not require choking or priming.
4.
pull it out slowly, until it pulls slightly harder. Let the rope
rewind slowly.
5.
snap back. Allow it to rewind slowly while keeping a firm
hold on the starter handle.
Repeat the previous steps until the engine starts.6.
As the engine warms up and begins to operate evenly, 7.
move the choke lever gradually to the RUN position. If the
engine falters, return to the choke position, then slowly
move to the RUN position.
8.
engine information.
NOTE: After starting and prior to using the tiller for the
first time, be certain to check the clutch adjustment as

Stopping the Engine

Disconnect the spark plug wire and ground it against the 2.
engine to prevent unintended starting.
NOTE: After the first ten hours of operation, recheck the
clutch adjustment. Refer to Clutch adjustment in the

Setting The Depth
Tilling depth is controlled by the depth stake which can be
adjusted to five different settings. Adjust the side shields as you
adjust the depth stake.

disconnected and grounded against the engine
when performing any adjustments.
When using the tiller for the first time, use the second 





Pin
Transportation
Position
1”
3”

7”

Operation
5
12