User Manual
EN - 28
8.
Current overload to cutting
1.
2. Obstructions that prevent
3.
10.
1.
2. Obstructions that prevent
3.
11.
repeating the starting procedure.
1.
2. Slope too steep .
3.
12.
drive pedal not released
(not in neutral position).
repeat the starting procedure
the drive pedal is in the neutral
position (pedal released).
13.
lever in drive disengaged position.
to the drive engaged position.
contact a Service Centre.
14.
repeat the starting procedure
installation of the batteries
in their respective slots.
contact a Service Centre.