Owner's manual

P71 Series Vertical Shaft Engines
100
9. Install the cylinder head by following the steps described in Chapter 9: Cylinder head.
10. Install the muffler by following the steps described in Chapter 8: Exhaust.
11. Install the flywheel and module by following the steps described in Chapter 7: Ignition system.
12. Install the blade brake, if equipped.
13. Install the fuel tank by following the steps described in Chapter 4: Fuel systems and Governor.
14. Install the carburetor by following the steps described in Chapter 3: Air Intake and Filters.
15. Install the blower housing and starter by following the steps described in Chapter 6: Starter.
16. Install the engine on the application by following the steps described in the application’s service manual.
17. Install the spark plug by following the steps described in Chapter 7: Ignition system.
18. Fill the engine with oil and fuel by following the steps described in Chapter 1: Introduction.
19. Test run the engine in a safe area and make any carburetor and governor adjustments needed.