Manual

Cub Cadet Commercial M60 Tank - 2002 and prior years
8
8. Disconnect the PTO clutch connector from the
wiring harness connector using a small flat-blade
screw driver. See Figure 4.
9. Roll the drive belt up and off of the right transmis-
sion pulley. See Figure 5.
10. Push the drive belt up and over the right hydro-
static input shaft, hydro pulley fan and transmis-
sion pulley.
11. Push the drive belt up and over the left hydro-
static input shaft, hydro pulley fan and transmis-
sion pulley.
12. Remove the drive belt from the engine drive pul-
ley. See Figure 6.
13. Inspect the drive belt for damage or wear.
14. Install the hydrostatic drive belt in the reverse
order above.
Figure 4
Wiring Harness
PTO Clutch Connector
Figure 5
Transmission
Pulley
Drive Belt
Figure 6
Engine Drive
Pulley